Gann Electrode Pins without insulation 20 mm
- SKU:
- 31004600
Related Products
Related Products
Gann Electrode pins non-insulated - 60mm (pack 100)
Gann
$55.00
Can use with the Trotec Hand Held Pin Probe
Non-isolated electrode pins show the most humid location in the material cross-section.
Maximum penetration depth: 54 mm / 2,5 mm (diameter)
For M 6...
Gann Electrode pins non-insulated - 16mm (pack 100)
Gann
$49.50
Can use with the Trotec Hand Held Pin Probe
Non-isolated electrode pins show the most humid location in the material cross-section.
Maximum penetration depth: 10 mm / 2,5 mm (diameter)
For M 6...
Gann Electrode pins non-insulated - 23mm (pack 100)
Gann
$49.50
Can use with the Trotec Hand Held Pin Probe
Non-isolated electrode pins show the most humid location in the material cross-section.
Maximum penetration depth: 17 mm / 2,5 mm (diameter)
For M 6...
Gann Electrode pins non-insulated - 40mm (pack 100)
Gann
$55.00
Can use with the Trotec Hand Held Pin Probe
Non-isolated electrode pins show the most humid location in the material cross-section.
Maximum penetration depth: 34 mm / 2,5 mm (diameter)
For M 6...
Gann Electrode pins Teflon - 45mm
Gann
$121.00
Can use with the Trotec Hammer Probe
The insulation prevents the measurement from being affected by surface moisture.
The front part of the tips is uninsulated, therefore, layer measurements may also...
Gann Electrode pins Teflon - 60mm
Gann
$121.00
Can use with the Trotec Hammer Probe
The insulation prevents the measurement from being affected by surface moisture.
The front part of the tips is uninsulated, therefore, layer measurements may also...
Gann M6 plug-in Electrode Carrier pair with pins
Gann
$121.00
The M 6 stick-in electrode pair can be used for resistance-based structural moisture measurement in hard-set building materials (such as lime-sand brick, cement screed or concrete) or...
Gann Stick-in Electrode pins M20-Bi 300 (pair)
Gann
$231.00
The stick-in electrode pins M 20-Bi 300 are used for measurement of materials hidden beneath another panel or covering. The pair of electrodes is isolated on the stem.
Gann M20 Drive-in Electrode
Gann
$110.00
The M 20 is a drive-in electrode for measuring wood moisture and building moisture. It is based on the resistance principle of measurement and can be connected to all corresponding...