Gann M 18 V2 Electrode support
- SKU:
- 31003509
Related Products
Related Products
Gann Cap nut for M 18 electrode support Ø 2,7 mm
Gann
$15.40
They are only used in connection with a ram-in electrode M 18 or a drive-in electrode M 20.
Gann M20 Drive-in Electrode
Gann
$110.00
The M 20 is a drive-in electrode for measuring wood moisture and building moisture. It is based on the resistance principle of measurement and can be connected to all corresponding...
Gann M18 Ram-in Electrode
Gann
$353.00
The M 18 is a ram-in electrode for measuring wood moisture. It is based on the resistance principle of measurement and can be connected to all corresponding measuring devices.
The...
Gann Electrode pins Teflon - 45mm
Gann
$121.00
Can use with the Trotec Hammer Probe
The insulation prevents the measurement from being affected by surface moisture.
The front part of the tips is uninsulated, therefore, layer measurements may also...
Gann Electrode pins Teflon - 60mm
Gann
$121.00
Can use with the Trotec Hammer Probe
The insulation prevents the measurement from being affected by surface moisture.
The front part of the tips is uninsulated, therefore, layer measurements may also...
Gann M25-300 Brush Electrodes (pair)
Gann
$198.00
The brush electrode pair M 25-300 is used for the resistance-based moisture measurement in hard and soft building materials.
The handling is very simple: The brush heads are screwed into...
Gann M25-100 Brush Electrodes (pair)
Gann
$176.00
The brush electrode pair M 25-100 is used for the resistance-based moisture measurement in hard and soft building materials.
The handling is very simple: The brush heads are screwed into...
Gann Deep Measuring Electrodes M21-250 (pair)
Gann
$275.00
The deep electrodes M 21-250 were designed to measure the moisture content in structural moisture; in particular for deep measurements of all kinds of building materials.
By using the deep electrodes...
Gann Electrode Pins without insulation 20 mm
Gann
$49.50
Can use with the Trotec Hand Held Pin Probe
Non-isolated electrode pins show the most humid location in the material cross-section.
Maximum penetration depth: 8 mm / 1,6 mm (diameter)
For moisture...